Howdy,
I am currently looking for high numbers of rice stink bug in sorghum (even in fields past where they can cause damage), as well as populations of sugarcane aphids to collect. If you’ve got a field with either of those, please give me a call or send me an email. I’ve also been recording and editing weekly audio updates with Dr. David Kerns, Tyler Mays, and Dr. David Drake. Our other IPM agents and specialists are recording as well, so if you’d like to hear what’s going on with us or with my coworkers across the state, check those out. If you sign up, you’ll receive a text message when the update posts with a link to the recording. You can sign up or listen at this website.
Cotton Field in Matagorda County Kate Crumley |
This week most of our cotton is between 4-8 nodes above white flower (NAWF), and our later replanted cotton is starting to bloom. We are checking for stink bugs and bollworms in almost all of our cotton, but our scouting has been limited this week due to the near constant rainfall.
Large H. zea Larva Kate Crumley |
Our scouting guide recommends checking in the top 1/3 of the plant, but it’s important to also pull bolls and flowers from lower to check as well. Egg lay has been occurring low in the plant as well, and it’s not uncommon to find small larvae or eggs in flowers and bloom tags. We also have seen small larvae feeding and entering bolls either on the very tip of the boll, or along the seams of the bolls. This makes the entry wounds more difficult to find, but the damage is easy to see if you pop open the bolls.
Our Bt traits overlap across corn and cotton. If the caterpillars survive the traits on corn then as adults fly to cotton to lay eggs, it’s likely their offspring will survive the same traits on cotton. The chart above shows the overlap of Bt traits between crops and technologies.
H. zea Eggs on Cotton Kate Crumley |
To scout for cotton bollworms I use the terminal and square inspection method. I make about four stops in a field, more if the field is larger than 100 acres. At each stop, I look at 25 plants, checking the entire plant, including blooms and under bloom tags, for caterpillars and eggs. I also pull 25 half grown or larger green squares to bolls and look for bollworm damage. When documenting egg lay, if I find more than one on a leaf, I only count it as one. This caterpillar is highly cannibalistic, and generally only one caterpillar will result from eggs too near each other. The economic threshold for bollworms is 6% damaged bolls with live caterpillars present. In areas like ours on the upper gulf coast with documented Bt failures, the threshold for eggs on single and dual gene cotton is 20% (20 plants out of 100 with at least one egg). Bolls with slight dark indentations like the photo below could be chewing damage from bollworms. Look closely at dark spots to see what they’re from. Early superficial damage like the photo below is unlikely to cause fruit drop, but if the caterpillars survive or get through the carpal walls, it can quickly become a problem.
We’ve picked up a few stink bugs, and a few consultants have recommended treatment for them in their fields. Check the inside of the bolls for warts, lesions, and stained lint. Above is a photo of a boll with potential stink bug feeding damage from the outside, note the slightly raised look of the dark spots. Be sure to open the bolls to confirm it is damaged, other sucking plant bugs may be unable to get through the carpal walls, and the inside will be clean. The economic threshold can be found below, depending on how long the field has been blooming. It is based on the percent damaged bolls with live bugs present. This year we’ve mostly seen brown stink bugs in cotton so far, and some of the brown stink bug populations in our area have been shown to have some resistance to pyrethroids.
Red Banded Stink Bug, showing ventral spine David Kerns |
Green Stink Bug, showing short spine David Kerns |
Check out our weekly IPM Audio Updates, the link is below. As always, if you have any questions feel free to contact me either by email or calling the office. Have a good weekend everyone!
Check out our weekly IPM Audio Updates
Plant Growth Regulators as Tools for Challenges